MegaGRRL_Desktop issueshttps://git.agiri.ninja/natalie/MegaGRRL_Desktop/-/issues2019-11-25T08:34:52Zhttps://git.agiri.ninja/natalie/MegaGRRL_Desktop/-/issues/3pcb 1.2 issues2019-11-25T08:34:52Znataliepcb 1.2 issues* [x] psg trimmer -> 100k
* [x] move power switch fet back where it was???* [x] psg trimmer -> 100k
* [x] move power switch fet back where it was???natalienataliehttps://git.agiri.ninja/natalie/MegaGRRL_Desktop/-/issues/2pcb 1.1 issues2019-11-21T08:04:16Znataliepcb 1.1 issues* [x] flip D3 to match D1/D2
* [x] heatsink hole sizes
* [x] power sw mounting holes need to be plated
* [x] big pin 1 marker for the led driver on the back
* [x] improve routing regarding MOR
* [x] remove stupid dot from power sw,...* [x] flip D3 to match D1/D2
* [x] heatsink hole sizes
* [x] power sw mounting holes need to be plated
* [x] big pin 1 marker for the led driver on the back
* [x] improve routing regarding MOR
* [x] remove stupid dot from power sw, put on/off on silk
* [x] move power jack back a few mil
* [x] move usb jack back a bit
* [x] why is c32 where it is?
* [x] vent slots under heatsink?
* [x] test points
* [x] C13 footprint probably still too small
...
* [x] change heatsink slots to drills
* [x] remove dot from sdcard footprint
* [x] tighten up filters again...
* [x] add TPs for EX_A and EX_B
* [x] decrease gain at audio ampnatalienataliehttps://git.agiri.ninja/natalie/MegaGRRL_Desktop/-/issues/1pcb 1.0 issues2019-10-23T06:41:39Znataliepcb 1.0 issues1.0? rushed? you don't say.
* [x] capacitor sizes
* [x] power switch
* [x] audio pulldowns
* [x] dipswitch legend
* [x] psg trimmer label
* [x] power through diode instead of backwards thing
* [x] rounded corners
* [x] "desk t o...1.0? rushed? you don't say.
* [x] capacitor sizes
* [x] power switch
* [x] audio pulldowns
* [x] dipswitch legend
* [x] psg trimmer label
* [x] power through diode instead of backwards thing
* [x] rounded corners
* [x] "desk t op"
* [x] adjust drc for tented vias
* [x] url under logo slightly too far to the right
* [x] led driver 2 channel 0 grounded
* [ ] opamp gain and filtering
* [ ] headphone amp gain
* [x] trimpot disaster
* [x] don't forget ver no
* [x] move vias under led drivers away from pins
* [x] move esp vias
* [x] heatsink holes
* [x] component labels
* [x] the new routing on audio_lineL and lineR that goes into the amp input resistors sucksnatalienatalie